CANTEK | JEN60 Drawer Notcher

by Cantek
$9,240.00
SKU WSI-CantekJEN60

Adding undermount hardware to your cabinet drawers just got easier.

The Cantek JEN60 Drawer Notcher is designed to both notch and drill drawer boxes to install undermount soft-close drawer slides.  The operation of the machine is simple with a self-indexing drilling unit that’s determined by the position of the drawer for either left or right notching.  With a cycle time of approximately 10 seconds per drawer, you can achieve a high throughput and save time for other important tasks.

  • High production capacity of up to 220 drawers machined per hour.
  • 57mm (2 ¼”) wide cutter head allows you to machine notches for a wide range of undermount drawer slides without needing to change heads or machine the component twice.
  • Self-indexing drill unit for left or right drawer notching.
  • Convenient foot pedal operation lets operator efficiently load and unload drawers for higher output.
  • Pneumatic cutter & drill stroke by foot pedal operation.
  • Cutter stroke and drill speed are adjustable for optimum finish results
  • Drill will automatically position for both left and right drawer notches by activating a switch in the fence
  • Machine will not cycle unless a drawer is up against the switch for safe operation
  • Insert knife cutterhead with solid carbide inserts for optimum finish results and long tool life
  • 2 ¼” (57mm) wide cutter allows for a wide range of undermount slides
  • Comes with insert cutterhead with inserts and ¼” (6.3mm) solid carbide drill bit.
  • Capable of notching up to 220 drawer boxes (both left and right) per hour.
Main cutter motor
3 HP
Notch dimensions
2 ¼” (57mm) x 0.5” high
Cutter diameter
10”
Drill diameter
¼”
Table size
49” x 22”
Table height from floor
32”
Dust port
4” (670 CFM requirement)
Compressed air required
90 – 100 PSI
Machine dimensions
48” x 37 ¾” x 39 ¾”
Machine weight
506 lbs.

Powered by Top Rated Local®